3
Installation
Do not install camera by yourself.
In case you install the camera by yourself, you assume responsibility for correctness of installation and hence for exploitation and
the quality of the image displayed.
It is recommended to turn to the service center to get a better result.
Please read the following instructions and choose the installation method that best suits your vehicle and product type purchased.
A: Attach the camera below the trunk lid, usually above the license plate. Use the fixing parts included to prevent from theft. Cable can
entry through the hole of license-plate's light. Provide a proper isolation.
B: To fix the camera inside the vehicle salon, you can use the bracket included. It is recommended to use the fixing parts included in the
box. During installing, you can possibly need to bend the bracket. In this case, ensure that such reshaping will not worsen camera
fixation and will not cause malfunction of the camera.
C: If you want to install the camera by the cutting-in method (provided the camera is designed for this method), drill a 23-26 mm diameter
hole in the rear bumper or another part of the vehicle body (select a suitable hole size based on the fixing place and surface thickness).
You are free to choose the place to fix the cut-in type camera; we can only give recommendations. When the camera is installed in the
hole until it is fixed, adjust the needed tilt angle and then fix it finally in the place prepared.
D: Regardless of the mounting place and exploitation purposes (control of rear, lateral or front part of the vehicle), the mounting rules
remain the same. It is necessary to ensure fixation of the camera secure and safe both for the driver and for other traffic participants.
Camera exploitation rules should not contradict to general Traffic rules or other regulatory acts and laws of the country in which a
vehicle with this camera is used.
