POW302
EN
Copyright © 2015 VARO
P a g e
|
5
www.varo.com
If there are devices for connecting dust extraction and collection facilities, please ensure
that they are attached and used correctly. Using such devices can reduce dust-related
hazards.
5.4
Power tool use and care
Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
Do not use the power tool if the switch cannot turn it on and off. A power tool with a
broken switch is dangerous and must be repaired.
Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.
Maintenance. Check for misalignment or jammed moving parts, breakages or any other
feature that might affect the operation of the power tool . If it is damaged, the power tool
must be repaired . Many accidents are caused by using poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5
Service
Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 SPECIFIC SAFETY WARNINGS
Do not remove any mechanical or electrical protective devices.
Check that all the protective devices are in place and have been correctly attached.
Wear safety goggles during drilling.
If you have long hair, be sure to wear hair protection (hair net or cap). Long hair can easily
get caught in moving parts.
Wear fitted clothing; tie buttons on sleeves.
Do not hold workpieces in your hands when drilling. Always use a tool clamp or another
clamping tool.
Protect workpieces and clamping tools on the bench to prevent them from getting caught.
Fasten them yourself with screws or clamp them with the tool clamp attached to the
bench.
Check that the drill holder is properly tightened.
Check that cable lead-throughs are intact.
To remove drill chips use only hand brushes, brushes, rubber wipers, chip hooks or similar
aids.
Do not attempt to clean or grease while the tool is running.
Always keep V-belts covered (to prevent your hands from getting caught).
Tighten the toothed ring drill holder solely with the wrench provided.
Never leave the wrench of the drill holder in the drill holder! Before switching on the tool,
double check that the wrench has been removed!
Do not use any drills with a damaged shank.
Drill is not suitable to use as press!
