Varimixer KODIAK V20KT, Operating Instructions And Spare Parts Lists

Page: 14 / 32

14
Error codes and possible solutions:
For some errors, the control system will show an error code in the display:
User pressed without raising the bowl to working height.
Solution : Raise bowl to working height.
User pressed without fitting the safety guard.
Solution : Fit the safety guard.
The Thermal sensor in the motor has overheated.
Solution : The error will disappear when the temperature has dropped to an acceptable level.
Stop the machine and reduce the quantity of ingredients in the bowl. When it starts again, select a lower speed.
There is an error in communication between the control panel and the frequency converter.
Solution: Call the engineer.
Error in frequency converter.
Solution : Call the engineer.
Thermal sensor in the frequency converter has cut out.
Solution
: The error will disappear when the temperature has dropped to an acceptable level.
Intermittent low voltage in the power supply.
Solution : The power supply to the machine should be checked by an expert.
Intermittent high voltage in the power supply.
Solution
: The power supply to the machine should be checked by an expert.
[ EE:14 ] Wrong parameter in frequency converter
Solution: Call the engineer, reference - Varimixer instruction 23020-1602
The machine is overloaded - continuously for 50 seconds.
Solution : Reduce the quantity in the bowl; alternatively, the product may need to be divided into smaller parts or diluted before
the machine is restarted. When restarted, select a lower speed, if speed was the problem.
The error code is removed by pressing
The machine is overloaded - momentarily (overloaded 8 times within 20 seconds.
Solution : Reduce the quantity in the bowl; alternatively, the product may need to be divided into smaller parts or diluted before
the machine is restarted. When restarted, select a lower speed, if speed was the problem.
The error code is removed by pressing
Blockage.
Solution : Remove the object that caused the blockage.
The error code is removed by pressing
, and can also occur when using the attachment drive.