Varian VS PR02x, Operation Manual

Page: 38 / 58

VS Series Leak Detector Wireless Remote
2-10
DRAFT 11
/2/06
2.2.5 Communication Setup Screen
Use this Setup screen (Figure 2-9) to choose the leak detector that the wireless remote is
associated with, if there is more than one potential leak detector host. The first choice
allows you to select a wireless remote from the known list of available leak detectors. The
second choice allows you to search for all available leak detectors and present a selection
list of leak detector MAC sub-addresses.
Figure 2-9 Communications Setup - Initial
Use this screen to navigate to the three sub-screens to:
❑
Use the SELECT screen to choose a leak detector from a list of leak detectors within
communications range that are is not already connected. While up to 10 leak
detectors MAC addresses can be configured at one time, only one connection can
be active (Section 2.2.5.1 “Choose Leak Detector” on page 2-11).
❑
Use the Search screen to scan the area for available leak detector RF channels (from
1 to 19) and then choose a leak detector from a list of leak detectors within
communications range (Section 2.2.5.2 “Scan and Choose a Leak Detector” on
page 2-14).
❑
Use the MAC addresses screen to verify the leak detector and wireless remote
addresses (Section 2.2.5.3 “MAC Address Verification” on page 2-16).