Vari Lite VL3500 Spot Luminaire, User Manual

Page: 27 / 88

I
NSTALLATION
: P
OWER AND
D
ATA
C
ABLING
R
EQUIREMENTS
2
0 2 . 9 6 8 6 . 0 0 0 1 A 21 - De cem be r- 20 07 9
Data Cables
The VL3500™ Wash Luminaire is equipped with two, 5-pin XLR connectors for DATA IN and
DATA THRU (out) applications. DATA IN requires a 5-pin, female XLR connector and DATA
THRU requires a 5-pin, male XLR connector. When purchasing or constructing data cables, it is
important that not only the correct cable type be used, but also quality cable to ensure a reliable
DMX512 system. Your cabling should meet the following USITT DMX specification requirements:
• Suitable for use with EIA485 (RS485) operation at 250k baud.
• Characteristic impedance 85-150 ohms, nominally 120 ohms.
• Low capacitance.
• Two twisted pairs.
• Foil and braid shielded.
• 24 AWG minimum gauge for runs up to 1000 feet (300m).
• 22 AWG minimum gauge for runs up to 1640 feet (500m).
Note: Microphone type cables and other general purpose, two-core audio or signal cables are not
suitable for use with DMX512.
The XLR 5-pin connectors should be wired as follows:
Note: Refer to the USITT Recommended Practice for DMX512 guide for additional information
regarding DMX512 systems. How to obtain a copy is detailed in “Additional Documentation” on
page 1 .
Pin/Wire Code to XLR Connectors
Data Thru
Cable Pinout
Male Conn
Pin 1
Foil &
Braided
Shield
Pin 2
1st
conductor
of 1st
twisted
pair
Data (-)
Pin 3
2nd
conductor
of 1st
twisted
pair
Data (+)
Pin 4
1st
conductor
of 2nd
twisted
pair
Data (-)
Pin 5
2nd
conductor
of 2nd
twisted
pair
Data (+)
Data In
Cable Pinout
Female Conn
1
2
3
4
5
1
2
3
4
5