Vari Lite VL3500 Spot Luminaire, User Manual

Page: 69 / 88

M
ENU
S
YSTEM
: S
ELF
-T
ESTS
4
0 2 . 9 6 8 6 . 0 0 0 1 A 21 - De cem be r- 20 07 51
Self-Tests
Running Parameter Tests
The luminaire is capable of running self-tests by using the
Test
menu functions.
When running tests on multiple luminaires, a male termination connector is required at the last
luminaire in the link. Refer to
“Connecting Data and Power” on page 15 for more information
regarding the construction of this connector.
Note: After 10 seconds of inactivity, the menu display changes to the default state showing the
address.
To connect luminaires for simultaneous testing:
Step 1. At last luminaire, install male termination connector into DATA THRU XLR connector.
Step 2. At master luminaire Menu Display, press [Menu].
Figure 4-2: Testing Setup
WARNING: Light Beam Projects Intense Heat
Do not illuminate objects within 3.5 m (11.5 feet) of the VL3500™ Wash Luminaire. Objects within
this range can scorch, melt, or ignite from the heat projected by the light beam.
To run tests:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until
Test
appears. Press [Enter].
Step 3. Use [Up] / [Down] arrows to select a parameter to test. Refer to “Menu System Function
Chart” on page 45 for a complete list of test parameters which can be chosen.
Step 4. Press [Enter] to run test.
Step 5. Press [Menu] to stop test at any time.
DATA THRU
ENTER MENU
AC PWR
DATA IN
~
AC IN
DATA THRU
ENTER MENU
AC PWR
DATA IN
~
AC IN
DATA THRU
ENTER MENU
AC PWR
DATA IN
~
AC IN
Termination Connector
Master Luminaire Luminaire 1 Luminaire 2
Data Thru Data Thru