VARCO PRUDEN SSR 900, Manual

Page: 21 / 24

4. Other uses of hand crimping tool:
SSR - Seam ends at upper and lower seams at roof curbs.
SSR - Seam ends at upper and lower seams at roof stacks.
SSR - Seam ends at valley/multi-gutters.
SSR - Seams near parapet walls, wall to roof areas and roof height change
SSR - Seams that are too close for proper clearances of the SSR seamer
tool operation.
4 3/4"
FEMALE RIB
MALE RIB
*NOTE:
The 4 3/4" dimension must be held to assure correct operation
of the seamer tool and fit up of accessories and closures.
Model No. VPHC-17
STEP 20.
STEP 1 & 2. (page 19 & 20 of this manual)
STEP 1 & 2. (page 19 & 20 of this manual)
18
areas.
1. Hand Crimp of "Starting End of SSR" for the seamer tool operation - "Female
Leading Edge Only" as shown in
2. Hand Crimp of the SSR - Panel End Lap - "Female Leading Edge Only" as
shown in
3. Hand Crimp of "Finish End of SSR" For Complete Tightness - as shown in
VP Hand Crimping Tool is recomended for starting the seaming process but not
required. The hand crimping tool, if used properly, will provide a tighter, more
uniform seam upon which to start the seamer. The VP Hand Crimping Tool is
available from your VP Service Center at an additional cost.
2. VP - SSR HAND CRIMPING TOOL
SSR Joint Detail