Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
L225-A
•
Component jammed.
o
Have the electric tool checked or repaired.
•
Too much thrust, as a result the motor is dragging.
o
Use less thrust during the task.
(3) Motor gets hot.
•
Foreign substances have got inside the motor.
o
Have the foreign substances removed.
•
Lack of or contaminated lubrication grease.
o
Have lubricating grease applied or replaced.
•
Pressure too high
o
Use less thrust during the task
(4) Frequent or strong sparks on the commutator.
•
Short circuit on the armature.
o
Have the armature replaced.
•
Carbon brushes worn out or jammed
o
Have the carbon brushes checked.
•
Rough running of the commutator.
o
Have the surface of the commutator cleaned or ground.
For your own safety, never remove parts or accessories of the electric tool during operation. In case of fault or
damage have the electric tool repaired only by a specialist workshop or by the manufacturer.
