Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
L225-A
4) Power tool use and care
a)
Do not force the power tool. Use the correct power tool for your application.
The correct power tool will do the
job better and safer at the rate for which it was designed.
b)
Do not use the power tool if the switch does not turn it on and off.
Any power tool that cannot be controlled with
the switch is dangerous and must be repaired.
c)
Disconnect the plug from the power source and/or the battery pack from the power tool before making any
adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of
starting the power tool accidentally.
d)
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e)
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use.
Many
accidents are caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp cutting edges are less likely to bind
and are easier to control.
g)
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the
working conditions and the work to be performed.
Use of the power tool for operations different from those intended
could result in a hazardous situation.
5) Service
a)
Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure
that the safety of the power tool is maintained.
PRECAUTION ON USING DRYWALL SANDER
Warning!
You must abide by the following basic safety measures against electrical shocks, injuries and the danger of
fire when using electric tools. Read and abide by these instructions before you start to use any tools. These
instructions must be kept in a safe place.
•
The equipment must never be used in surroundings where an explosive atmosphere exists.
•
Do not let the cable touch any parts of your body.
•
Only use the extension cable approved for use in the working area.
•
Do not force the machine for unsuitable work, for example, rough grinding, brushing, etc. Otherwise, dangers
and harms will be caused.
•
Only use identical replacement parts when servicing. Otherwise, risk-free operation can’t be guaranteed.
•
The accessories’ allowed speed must be at least the same as the maximum speed of the machine. Or else,
they may be broken or cracked when their running speed is go over the machine’s allowed speed.
•
Do not use damaged accessories. Before use, always check whether the accessories are nicked or cracked.
For example, to grinding pad, please check the support plate is not cracked. Ensure everybody to be out of
the machine’s rotation area and run the machine at max. speed for one minute, which can fully test the
accessories.
•
Do not put down the machine when it isn’t stopped completely. Otherwise, you will loss control to the
machine.
•
Cleaning the exhaust port on your machine in regular.
•
When working, control the machine firmly with both hands to ensure safe operation.
•
When sanding, do not use too big sandpaper. When choosing grinding disc, please observe the
manufacturer's specifications. The sand paper beyond the grinding block leads to risk of cutting and injury
and cause stuck as well.
•
The machine can be connected to one extension tubes at most.
•
We recommend that you always wear industrial safety gloves and safety goggles when working with the
drywall sander.
•
Wearing close-fitting clothes is mandatory.
•
Always allow for reaction torque
•
Wear protection mask P2 to protect you from hazardous dusts and choose suitable vacuum cleaner.
