Page 18
3101126 Rev A Vapotherm Oxygen Assist Module Instructions for Use
The Oxygen Assist Module must always be cleaned and disinfected between patients. Follow the steps
below to ensure a clean and disinfected device.
•
Wipe down the main unit with Super Sani-Cloth
®
.
•
Examine for visible soil. If visible soil is present, use a brush (e.g. Spectrum M16 brush) to
remove visible soil.
•
Wet the module with another Super Sani-Cloth
®
. Keep the surface wet for at least six minutes.
Use additional Super Sani-Cloth
®
if needed.
Caution:
Do not use bleach, organic solvents or abrasive cleaners.
For cleaning and disinfecting instructions for the Precision Flow, see the Precision Flow Instructions for Use.
For cleaning and disinfecting instructions for the SpO
2
sensor and patient cable, see the instructions
provided with the sensor.
Section 14 Cleaning and Disinfecting
Section 17 Referenced Documentation
Precision Flow
Instructions for Use can be found at our website www.vapotherm.com
Section 15 Data Download
1.
Insert USB Drive into the Oxygen Assist Module.
2.
On the System screen, select Case Data and enter PIN.
3.
Choose which Case file or files to download and press Download button.
NOTE: Downloading multiple large case files may take several minutes to complete.
4.
Once data is saved, press OK and remove USB Drive.
5.
As needed, delete Case files to clear Local Storage.
Section 16 Software Updates
1.
Insert USB Drive with software file into the Oxygen Assist Module.
2.
On the System screen, select Updates and enter PIN.
3.
Select Update Software.
NOTE: System will reboot throughout the Software Update Process
