Set the DMX address. (FIG 4)
1. Choose MENU.
2. Use UP/DOWN buttons until D001 is displayed.
3. Choose ENTER
4. Use UP/DOWN to select the desired start address.
5. Choose ENTER.
6. DMX start address is now set.
Set Initial Air/Water Ratio (FIG 5)
1. Set AIR to 7.
2. Set WATER to 2.
3. NOTE: We have found this to be the ratio that works best
to create a full e
ff
ect plume with little or no water
collecting on the surrounding area.
Connect air/water supply (FIG 6)
1. Prime the Water supply hose by allowing water to
flow freely thus bleeding the air from the water line.
2. Align the notch on the air/water connector of the
supplied adaptor to the notch on the air/water
connector of the 6b.
3. Firmly seat the connectors until they click, and lock
into place.
4. Air supplied to the unit should be dry and free from air
compressor condensation.
5. NOTE:
Do not cross the streams!
Air and water
supply must not be reversed, this may cause
irreparable damage to the 6b unit.
6. NOTE: The supplied air should be set to 50psi.
(50-70psi is acceptable).
7. NOTE: The supplied water should be a nominal sink
tap pressure, free from debris, and can be any potable water. Water line should
have a fine mesh filter to keep debris out of the 6b.
Power the lighting fixture
1. Power the lighting fixture per console manufacturer’s instructions.
2. NOTE: the 6b should be attached to an outdoor rated LED fixture. Conventional
lighting fixtures may heat up and damage the hoses.
Page of
8
12
Rev. 2.0 11/20
Keypad Label
Scale: Actual Size
2
Menu Enter
Up
Down
63mm
[63.00]
45.2mm
[45.20]
FIG. 4
FIG. 8
