User Manual version 1 | page 5
Speci�c Installation
- Although this product does not generate a great amount of heat, it is
recommended that you do not cover or conceal it.
- Do not route the product through walls, doors, windows, or building structures.
- Do not roll out the product onto rough surfaces or over sharp corners. This will
scratch the PVC optics and damage the �nish of the product.
- Do not use the product if:
The outer PVC jacket is damaged
There are loose electrical connections
The wires are visible without insulation.
- Do not secure the product with staples, nails, or alike that might damage the
insulation or PVC material.
- Do not install the product on/in places where it is subject to continuous �exing.
- Do not operate/run the product in temperatures exceeding 45C or 113F.
- Do not operate the product over the speci�ed voltage or LED life degradation
will be greatly increased.
- Do not leave any part of the product unsecured.
- Constant movement over time from weather can cause damage.
- Do not reverse polarity when connecting from both ends. This will damage the
internal PCB. Always test connections with a multi-meter before applying power.
- Do not energise the product whilst in packaging.
- The product can be cut only where marked. Look for the “Dotted Line” or
“Scissor Mark”. A cut section must have the appropriate
IP rated cap
�ex
accessory to maintain IP ratings.
- Cutting outside of the speci�ed mark will damage the light.
- Do not cut while the LED �ex neon is connected to power.
- Do not install in human inhabited pools.
- Must always be used with an electrical isolation transformer providing SELV
(safety extra low voltage).
This user manual is intended to cover as
much detail as possible for this product,
and great care has been taken to ensure
this and the accuracy of the information
contained within, however should
additional information or clari�cation be
required that is not covered within this
manual or associated data sheets, or if
there are any uncertainties regarding the
installation and operation of this product,
Distributor MUST be contacted before
any work is carried out on the �xture or
associated products.
FAILURE TO COMPLY WITH THIS
MANUAL AND LOCAL ELECTRICAL
AND CONSTRUCTION REGULATIONS
MAY RESULT IN SERIOUS INJURY
OR EVEN DEATH - ALWAYS ISOLATE
POWER BEFORE WORKING ON
ELECTRICAL PRODUCTS AND ENSURE
ADEQUATE MEASURES ARE TAKEN TO
MECHANICALLY SUPPORT FIXTURES AT
ALL TIMES.
Caution, risk of electric shock
The light source and other
electronic components
contained in this luminaire
shall only be replaced by
y
or an approved
our distributor
service agent.
- Do not cut off the cable wire between the waterproof treatment and connector.
Summary of Contents for LED neon flex
Page 1: ...LED neon flex User Manual...
