![background image](http://html1.mh-extra.com/html/vango/evolution-evmx8x6/evolution-evmx8x6_manual_3379078007.webp)
www.vanco1.com
800.626.6445
7
6
Rear Panel
1. INPUTS: Connect HDMI sources to each corresponding HDMI input
2. OUTPUTS:
•
1-6-HDBT: Connect HDBaseT receiver(s) to each output, option of the EVRXHD2 or EVRXDSC PoC
receivers
•
7-8-HDMI: Connect HDMI displays via HDMI cables; if needing to extend this signal over Cat5e/6, an
HDBaseT extender is strongly recommended
3. IR OUT:
•
1-8: Connect the included IR Transmitters (TXs) to each port, the number on the IR output corresponds
to the HDMI inputs. Connect this if you would like to control the sources from each display location over
HDBaseT (receiver(s) have IR inputs)
•
ALL OUT: Connect the included IR Transmitter (TX) to this port, this will send an IR signal from any
HDBaseT receiver regardless of the HDMI signal routing; useful feature to turn on/off an external
amplifier or audio distribution system at any display location
4. IR IN:
•
1-6: Connect the included IR Receivers (RXs) to each port, the number on the IR input corresponds to
the HDBaseT outputs. Connect this if you would like to control the display(s) over HDBaseT (receiver(s)
have IR outputs)
•
ALL IN: Connect the included IR Receiver (RX) to this port, this will send an IR signal out to all HDBaseT
receiver(s); useful feature to turn on/off all displays at one time
5. AUDIO OUTPUTS: Digital optical outputs and analog RCA outputs for HDMI outputs 7 and 8
6. CONTROL:
•
TCP/IP: Connect to a local network such as a router or ethernet switch to give the matrix unit
connectivity, this will give the ability to control the matrix unit via IP with any device on the network such
as a computer, tablet, or mobile phone
•
RS-232: Connect the included RS-232 cable to a computer or 3rd party control system for integration
•
IR EYE: Connect the included IR Receiver (RX) to this port, this can be used to control the matrix unit
with the included IR remote; also a helpful feature to hide the matrix unit and lead out the IR Receiver to
a different location for remote control
•
FIRMWARE: Connect a Type-A USB cable to upgrade firmware, any available firmware updates will be
located on the product page for this part # on www.vanco1.com, under the “downloads” tab
7. DC 24V: Connect the included power supply
3
4
5
2
1