V&P Scientific, Inc.
8
Technical Note 378B
PRODUCT MAINTENANCE
GENERAL PRODUCT CARE
When not in use, turn the power switch off.
Do not place the control unit in chambers with temperatures above 40
o
C.
To clean the stirrer, wipe down with a cloth and mild detergent followed by a water wipe.
Do not
immerse SpinVessel® Motor or Control in liquid
.
The motor of the VP 418SV-1-1L-FB-CC SpinVessel® is a stepper motor, 100-240 Volts, 50/60 Hz, CE
compliant.
SAFETY PRECAUTIONS
The use of motor controls, like that of all utilization of concentrated power, is potentially hazardous.
The degree of hazard can be greatly reduced by proper design, selection, installation, and use, but all
hazards cannot be completely eliminated.
The following safety precautions must be observed during all phases of installation, operation, service,
and repair of this motor control product. Failure to comply with these precautions or with specific
warnings elsewhere in this manual violates safety standards of design, manufacture and intended use
of the products. V&P Scientific assumes no liab
ility for the customer’s failure to comply with safety
requirements and practices.
WARNING
To avoid personnel injury caused by electrical shock, do not
remove the cover of the controller when the power is ON.
CAUTION
Do not disconnect motor during operation. Otherwise, over-
current breakdown may result.
WARRANTY
V&P Scientific, Inc. warrants this product to be free from defects in material and workmanship when
used under normal laboratory conditions for one year. This warranty begins from the date of delivery
by V&P Scientific.
In the event this product fails under normal laboratory conditions within the specified period of time
because of a defect in material or workmanship, V&P Scientific will, at its option, repair or replace the
product. Damage to the product caused by user negligence is not covered.
