www.vanco1.com
800-626-6445
5
PANEL DESCRIPTIONS
1. RS232 port: Connect an RS-232 source, which will send signal to RX unit via Cat5e/6.
2. HDMI input: Connect an HDMI cable from the source such as a Bluray player or Cable/Sat Receiver.
3. HDMI Status: This LED will illuminate when the unit is receiving signal from the source
4. IR RX: Connect the IR Receiver (See below for bi-directional IR information), plugging the IR RX cable into the
Transmitting unit would mean controlling the display from the source.
5. IR TX: Connect the IR Transmitter (See below for IR information), plugging the IR RX cable into the Transmitting
unit would mean controlling the source from the display.
6. EDID DIP Switch: See EDID section for information on how to set EDID.
7. Firmware Upgrade DIP Switch: To be reserved for any future firmware upgrades to the unit.
8. Link Status: This LED will illuminate to indicate it is sending a signal over the Cat5e/6 cable.
9. HDBaseT Output: Connect a single Cat5e/6 cable to this output; recommendation is to run a “home run” cable
with no splicing, coupling, patch panel, etc. to avoid signal loss.
10. Power Status: Illuminates to indicate that the unit is powered on.
11. DC 12V Port: (Optional - PoE) Connect the included DC 12V power supply to an outlet or power source, if not
utilizing the power supply on the Transmitting unit, the power supply will need to be plugged into the Receiving
unit.
12. Firmware Toggle Switch: To be reserved for any future firmware upgrades to the unit.
13. Link Status: This LED will illuminate to indicate it is receiving a signal from the Transmitting unit.
14. HDBaseT Input: Connect a single Cat5e/6 cable to this input; recommendation is to run a “home run” cable with
no splicing, coupling, patch panel, etc. to avoid signal loss.
15. Power Status: Illuminates to indicate that the unit is powered on.
16. DC 12V Port: (Optional - PoE) Connect the included DC 12V power supply to an outlet or power source, if not
utilizing the power supply on the Receiving unit, the power supply will need to be plugged into the Transmitting
unit.
17. RS232 port: Connect an RS-232 sink that will receive the serial codes from the Transmitting unit via Cat5e/6.
18. HDMI Output: Connect an HDMI cable from the display such as an HDTV or a projector.
19. HDMI Status: This LED will illuminate when the unit is connected to an active display.
20. IR RX: Connect the IR Receiver (See below for IR information), plugging the IR RX cable into the Receiving unit
would mean controlling the source from the display.
21. IR TX: Connect the IR Transmitter (See below for bi-directional IR information), plugging the IR TX cable into the
Receiving unit would mean controlling the display from the source.
1
2 3
4
6
8 9
1011
12
7
13
14
Transmitter
Receiver
5
16
15
17
18 19
21
20
Summary of Contents for 280621
Page 10: ...www vanco1 com 10 ...
