www.vanco1.com
800-626-6445
8
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input on the Transmitting unit.
2. Connect a display such as an HDTV or HD Projector to the HDMI output on the Receiving unit.
3. Connect a single Category 5e/6 up to 164ft/50m to the output of the Transmitting unit, and the other end
to the input of the Receiving unit.
4. For power, plug both the Transmitting unit and Receiving unit with the included power supplies.
5. Power on each device starting with the source, and then the display (receiver and transmitter will already
be powered when either unit is plugged in.)
At this point the display connected should display the source signal connected to the extender set. If no signal
is being displayed, connect a shorter Cat5e/6 cable (jumper or patch cable). If a display is having difficulty
receiving a signal, see EDID section and perform EDID learning or access the display’s menu and adjust the
resolution (lowest to highest until signal is displayed). A 24 Hz vertical refresh rate may work better than 60
Hz or higher. Use the source remote at the receiver IR pigtail to test IR functionality. If the IR remote function
is not responding, check the emitters to ensure they are placed correctly and are plugged into the correct IR
jacks on the Extender set receiving and transmitting units.
