E2 - Replace Main PCB (Printed Circuit Board)
IMPORTANT NOTE:
Use extreme caution when servicing the lift. The PCB should be handled
with care. Use of proper E.S.D. protection to prevent damage to the circuit board is highly
recommended.
Contact with metal objects (screw drivers, rings, etc.) will damage the PCB.
1.
Before starting,
disconnect the RED battery wire
and all wire harnesses and all air tubes
(remove off from the steel pins) from the PCB.
2.
Before installation of new PCB, test the new PCB to ensure that the diagnosed problem will
be solved. Attach all wire harnesses and reconnect the battery wire.
Test lift unit. If lift unit
still does not function, the problem is elsewhere.
Contact customer service for further
instructions.
3.
Remove the mounting screws (M3 x 8mm hex socket cap screw) using a 3mm allen key.
4.
Carefully remount the PCB and tighten screws.
Do not over-tighten screws
.
5.
Attach all wire harnesses and reconnect the battery wire. Test lift unit.
P-600 Technical Manual
REV: 101316
Page 16
Summary of Contents for P-600
