Vancare C450, Technical Manual

Page: 31 / 50

LCD Display & Programming Functionality
•
Change Setting Mode :
−
To change one of the programmable settings, the user should press the ‘Up’ and ‘Down’
buttons simultaneously when a particular setting is being displayed.
14. The display will then display the setting name and the setting itself. The setting
will then display as reverse-highlighted (as in the following example)
P R G M O E M D O R A
D i s p l a x y B A T
−
Once in Change Setting Mode, the user can cycle through the possible settings by using
the ‘Up’ and ‘Down’ buttons. The setting should remain highlighted as the user cycles
through their options.
−
To select the setting, the user then presses the ‘Up’ and ‘Down’ buttons simultaneously
for three (3) seconds. The lift should then:
15. Beep one (1) time.
16. Go back into Programming Mode and allow the user to cycle through the other
settings using the ‘Up’ and ‘Down’ buttons.
o
If the user does not press any buttons for ten (10) seconds while in Change Setting
Mode the lift should revert back to Programming Mode.
•
Programming Options :
−
The programming mode will offer the following choices:
1.– Display Mode (see above)
(i) Battery Level (factory setting)
(ii) Number of Lifts
2.– Traversing Speed;
(i) 2
(ii) 4
(iii)
8 (factory setting)
3.– Preventative Maintenance Alarm;
(i) On
(ii) Off (factory
setting)
4.– Maintenance
(i) Total Number of lifts (display only, not programmable)
(ii) Lifts since last maintenance (see ‘Preventative Maintenance’, below)
(iii) Total number of lift hours (display only, not programmable).
(iv) Total lift hours since last maintenance (see ‘Preventative
Maintenance’, below)
C-450/C-625 Technical Manual 031417 Page 31