8
6.
Attach the UV shield to the bottom front of the epi-illuminator housing assembly
with the UV shield set screw (see figure 4a).
Setup
7.
Slide the eyepieces into the eyetubes and attach eyecups (see figure 5).
8.
After removing the objectives from their storage containers, individually install
each one into the nosepiece by twisting them clockwise into the threaded holes
of the nosepiece (see figure 6).
9.
Raise the substage and stage to their maximum height. Raise the stage via the
coarse/fine focus controls (see figure 7a), and the substage using the substage
adjustment knob (see figure 7b).
10.
Loosen the condenser set screw (see figure 7c) enough to allow the neck of the
condenser to slide through the silver ring.
The next 4 steps describe how to install the condenser. With most microscopes the
condenser comes pre-installed. If this is the case skip ahead to step 13.
Assembly
(continued)
Figure 4
Figure 5
Figure 6
Figure 7
[a]
[a]
[b]
[c]
