Van Der Stahl V-460G Series, Operating Instructions Manual

Page: 34 / 116

V-460G/610G Series Operating Instructions Ver.4.02E
34
This chapter explains how to register a new operation pattern with following two samples.
Please read this chapter thoroughly before start registering the other operation patterns.
8-2-1 Sample case: register “seal only” operation mode
＝ Operation number “05”: seal (only)
Heating temperature 140ºC/280ºF , Heating time 0.3 seconds, Cooling temperature 100ºC/200ºF.
8-2-2 Sample case: register “1-GAS timer vac seal” operation mode
＝ Operation number “06”: timer vac seal
Heating temperature 140ºC/280ºF, Heating time 0.3 seconds, Cooling temperature 100ºC/200ºF
Vacuum time 12.0 sec, Gas timer 8.0 seconds, Nozzle stroke = N4
8-2 Register sample operation patterns
Attention
Maximum 10 operation patterns can be stored in the control unit.
If you are going to register over 10 operation patterns, the message “ALL 10 OPERATION PATTERNS
ARE ENTERED. DELETE ONE FOR A NEW ENTRY.“ is displayed on the screen.
You cannot input a new operation pattern until at least one of the stored operation pattern is deleted.
Attention
The biggest number is automatically assigned to a new entry.
E.g.) If there are 4 operation patterns already entered, the new entry number will be 05.