VAMP Ltd
Motor protection relay
Operation and Configuration
VAMP 150
VM150.EN005
Vamp 24h support phone : +358 (0)20 753 3264
23
5.8.
Configuring communication protocols
COM
Via the submenus of the COM menu the following functions
can be read and set:
Active
•
Communication protocol of REMOTE port (Protocol)
•
Message counter (Msg#)
•
Communication error counter (ERRORS)
•
Communication time-out counter (Tout)
Profibus
•
Profibus profile (Mode)
•
Transfer rate of converter
•
Profibus Tx Buf lentgh (InBuf)
•
Profibus Rx Buf lentgh (OutBuf)
ModBus
•
Device slave number at ModBus Slave Protocol
•
Target slave number at ModBus Master protocol (Addr)
•
ModBus transfer rate (bit/s)
•
ModBus parity check (Parity)
SpaBus
•
Slave number (Addr) when relay connected to SPA
substation
•
SPA-Bus transfer rate (bit/s)
•
Event mode (Emode)
IEC-103
•
Slave address (Addr)
•
Transfer rate (bit/s)
•
Interval for sending measurements (MeasInt)
•
ASDU6 response time mode (SyncResMod)
TCP/IP (ModBus TCP, only in VAMPSET)
•
IP address of the relay (IPAddr)
•
Subnet mask (NetMsk)
•
IP address of the Name Server
•
IP address of the SNTP Server (NTPSvr)
Local Port
•
Transfer rate of local serial bus (bit/s)