51
Revision D November 2022
Step 2
Slide the Fender Panel forward until the holes in the Fender Panel line up with the holes
in the forward Diaphragm.
Step 3
Use a drift pin to align the center hole of the Fender Panel with the center hole of the
Diaphragm.
Step 4
Attach the front of the Fender Panels to the next Diaphragm using two (2) rail bolts and
large hex nuts per side. Use only the top and bottom holes; leave the center hole open
until the next Fender Panel is attached.
Step 5
Be sure Mushroom Washer lays flat against the Fender Panel as shown in Detail 61a.
Standoff on Mushroom Washer must be seated completely through slot.
Figure 61
Fender Panel Assembly
