50
Revision D November 2022
8) Attach Hinge Plate onto Fender Panels
Note:
Do not mix the 5/8” rail nuts (large) with the 5/8” hex nuts (small) (Figure 59).
Note:
For proper impact performance, wide systems must use Hinge Plates.
Attach Hinge Plate on each Fender Panel using two (2) 5/8” rail bolts and two (2) 5/8” rail nuts,
using top and bottom holes only, leaving the center-hole open as shown in Figure 60.
9) Attach Fender Panels
Starting at the Backup, attach left and right Fender Panels as shown in Figure 61 and Fender
Panel Assembly drawing.
Step 1
Place the Fender Panel so that the center of the slot of the rearward Diaphragm is lined
up with the approximate center of the slot in the Fender Panel.
Attach Mushroom Washer Assembly as shown in Figure 61, Detail 61a and Detail 61b,
but do not torque at this time (this helps to balance the Fender Panel).
Figure 59
Rail Nuts are Oversize
Figure 60
Hinge Plate Assembly
