Valsi G120MG2200RV, Assembly And Operating Instructions Manual

Page: 7 / 24

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
7
CAUTION
When applying a load, do not exceed the
maximum wattage rating of the generator
when using one or more receptacles.
Also, do not exceed the amperage rating of any
receptacle.
CAUTION
Do not apply a heavy electrical load during
start period (the first two to three hours of
operation).
APPLYING LOAD
ASSEMBLY INSTRUCTIONS
SHUTTING THE GENERATOR OFF
INITIAL START PROCEDURE
This unit has been pretested and adjusted to handle its
full capacity. When starting the generator, disconnect
all loads. Apply load only after the generator is running.
Voltage is regulated via the engine speed adjusted
al the factory for correct output. Readjusting will void
warranty.
Remove entire electrical load.
Let the engine run for a few minutes with no load.
Move the engine switch to the “OFF” position.(turn the
key switch to “OFF” on the electrical start models).
Do not leave the generator until it has been completely
stopped.
Close the fuel shut off valve if the engine is to be put in
storage or transported.
If cover is used, do not install it untill the generator is
cool.
1
2
3
4
5
6
Controlled initial start helps insurance of proper engine
and generator operation. Follow engine start procedure
outlined in engine manual.
Before starting your generator, you must install the following
components: Handles, wheel kit, and battery holder (battery
is not included).
HANDLE INSTALLATION
1
2
3
4
6
5
Unpack and inspect all parts to see if there are not
missing or defective parts.
Find the 2 handles, the bolts and the pins.
Attach the handle to the frame using the holes to set
the handles.
Insert the bolt to hold the handle to the frame.
Set the pin in the bolt hole.
Repeat operations 3, 4 and 5 for the next handle
WHEEL INSTALLATION
1
2
3
Before mounting the wheels, make sure they are inflated
to a pressure between 15 psi and 20 psi, not exceeding
24 psi, as this could cause damage to you.
Insert the shaft to the base through the hubs of the
frame.
Support the generator in blocks of wood to a sufficient
height that allows the assembly of the rim and place the
spacing rings on both sides.
Insert both wheels on the axle and secure with pins.
4
FRONT SUPPORT INSTALLATION
1
2
Place the generator, without tires on wooden blocks,
allowing a place to install the front support.
Attach the front support to the frame with screws provided
and tighten securely, as shown in the drawing.