background image

     

Service and Installation Manual

 

11                                   

For warranty service, call 1-888-VALPRO8 / 1-813-502-030                 

                       

 

 

recommended that a separate circuit, serving only your ice maker, be provided. 
Use receptacles that cannot be turned off by a switch or pull chain. The fuse (or 
circuit breaker) size should be 15 amperes. 
 

Recommended grounding method 

For your personal safety, this appliance must be grounded. It is equipped with a 
power supply cord having a 3-prong grounding plug. To minimize possible 
shock hazard, the cord must be plugged into a mating 3-pronged and 
grounding-type wall receptacle, grounded in accordance with the National 
Electrical Code and local codes and ordinances. If a mating wall receptacle is 
not available, it is the personal responsibility of the customer to have a properly 
grounded, 3-prong wall receptacle installed by a qualified electrician. 
 

Leveling the Ice Maker 

It is important for the ice maker to be leveled in order to work properly. 

Otherwise water will not flow properly through the evaporator (ice mold). The 

ice production will be less than normal, and may be noisy. For VPIM-55/85 ice 

maker, you can be raised or lowered by rotating the plastic sheaths around each 

of the four rolling casters (see below) on the bottom of the machine. For 

VPIM-280 ice maker, you should adjust the feet by rotating the under block 

(see below) until the machine is level. If you find that the surface is not level, 

rotate the casters until the ice maker becomes level. You may need to make 

several adjustments to level it. We recommend using a carpenter’s level to 

check the machine. 

 
 
 
 
 
 
 
 
 
 

   

Service and Installation Manual   

 

 

 

             

For warranty service, call 1-888-VALPRO8 / 1-813-502-030                         

         

16

NOTICE: 

1.

 

The cleaning recommended indicator light will change from green, yellow 
to red according to the consumed water quantity. In the beginning the 
Cleaning Recommended Indicator Light is green, followed by yellow. 
When the light goes red, it warns you that replacement of a new one will be 
necessary.   

2.

 

We recommends you replace water filter for every 6 months. If the validity 
of the water filter is earlier than remind lamp, just refers to the validity of 
the filter to replace it, and vice versa. 

If you do not use a water filter, you needn’t set the initial data of water filter, 
and the cleaning recommended indicator light will be off under any working 
status. 

 

Operating Method 

1.

 

Turn on the water tap, then press the ICE button, all the indicator lights on 
the control panel blinking(Except the cleaning recommended indicator 
light

the light according to using a water filter or not), the water enter the 

water tank. 

2.

 

After about 2 minutes, the ice maker will automatically proceed to the 
ice-making stage, and the sound of flowing water will be heard. Only the 
green ice making indicator light lights. (Except the cleaning recommended 
indicator light) 

3.

 

When the batch of ice has been fully formed, ice will automatically fall into 
the ice storage bin. The yellow ice harvest indicator light will be on, and 
other indicator lights will be off. (Except the cleaning recommended 
indicator light) 

4.

 

When the ice storage bin is full, the sheet of cubes will not fall completely 
and will hold the ice slide way open. The machine is in the ice-full mode, 
and the red ice full indicator light is lit, and other lights will be off. (Except 
the cleaning recommended indicator light) 

5.

 

The unit starts making ice again automatically after ice cubes are

 removed. 

As ice is removed, the ice slide way swings back to operating 
position. 

 

Summary of Contents for VPIM55

















Reviews: