Service and Installation Manual
19
For warranty service, call 1-888-VALPRO8 / 1-813-502-030
Preparing the Ice Cube Machine for Long Storage
If the ice cube machine will not be used for a long time, or it is to be moved to
another place, it will be necessary to drain the system of water.
1.
Press the STANDBY button, the drain pump work, the water in the water
tank and the water line will be drain out.
2.
Shut off the water supply at the main water source.
3.
Disconnect the water supply line from the water inlet.
4.
Shut off the power supply at the main electrical power source.
5.
Take out the ice storage bin to remove ice. (See page19-23), dry and replace
the bin.
6.
Leave the door open to allow for circulation and to prevent mold and
mildew.
7.
Leave the water supply line and power cord disconnected until ready to
reuse.
IMPORTANT:
•
Do not touch the power plug when your hands are wet.
Never unplug the unit
by pulling on the cord.
Cleaning and Maintenance
Periodic cleaning and proper maintenance will ensure efficiency, top
performance, and long life. The maintenance intervals listed are based on
normal conditions. You may want to shorten the intervals if you have pets or
there are other special considerations.
What shouldn’t be done
Never keep anything in the ice storage bin other than ice: objects like wine and
beer bottles are not only unsanitary, but the labels may slip off and plug up the
drain.
Service and Installation Manual
For warranty service, call 1-888-VALPRO8 / 1-813-502-030
8
Unpacking
Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data
label on your ice maker.
Remove tape and glue from your ice maker before using,
•
To remove any remaining tape or glue, rub the area briskly with your
thumb. Tape or glue residue can also be easily removed by rubbing a
small amount of liquid dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
•
Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can damage
the surface of your ice maker.
•
Leave lowermost foam panel in place until after the adjustable feet are
attached.
Cleaning before use
After you remove all tape and glue from the machine, clean the inside of your
ice maker before using it. See “Interior Cleaning” in the Cleaning and
Maintenance section.
Installing the adjustable feet
For VPIM-280 ice maker, at least two persons are required to install the
adjustable feet.
You will find four adjustable feet packed in the ice storage bin. To install, tilt
one side of the unit and screw in two adjustable feet. (IMPORTANT: Do not
tilt the unit more than 45
º
) . Then tilt the other side and screw in the remaining
two feet.
Location Requirements
This ice maker should be installed by qualified personnel.
NOTICE:
1. Before setting the ice maker inside a cabinet, connect the water supply pipe
correctly.
Untie the drain hose, insert it into the drain, and connect the power supply
line.
2. Do not kink or pinch the power supply line between the ice maker and wall
or cabinet.
