Version 2019.1
www.valoya.com
+358 10 2350 300
Warnings and Explanations
3
RoHS
PATENTS APPLY
IMPORTANT
Installation must be carried out by qualified persons, and according to the electrical safety rules & regulations applicable in
your country!
1.
Please read this manual thoroughly before use, and retain it for future reference.
2.
Due to our continuous program of product development, data is subject to change without notice.
3.
Unauthorized product tampering invalidates warranty & is a safety risk.
4.
All electrical work must be carried out by qualified persons.
5.
Always follow appropriate electrical codes.
6.
Disconnect mains power before product installation, connection, or disconnection.
7.
Products are fixed luminaires for indoor use (i.e. Install out of reach / Only movable using tools).
8. LED-modules are non-replaceable light sources.
9.
Do not use luminaires without LED Drivers (power units) connected (BX-, C-Series).
10.
Connect LED drivers to electrical branch circuits (ensure suitable strain relief is fitted).
11.
Products with an earth connection must be earthed for safety.
12. Installation of additional electrical circuit protection devices is strongly advised:
•
Type C MCB’s (Miniature Circuit Breakers).
•
RCD (Residual Current Device).
•
ICL (Inrush Current Limiter).
•
SPD (Surge Protection Device).
13. Do not high voltage test.
14.
Install LED drivers against a flat surface to ensure optimal heat dissipation and lifetime (BX-, C-Series).
15.
Do not connect products installed on different mains phases to the same dimming device (dimmable products only).
16.
Observe published product temperature specifications and limits.
17. Product surface temperature may become hot to the touch during use.
18. Do not stare directly at any bright light source.
19.
As a precaution, use suitable eye protection if working for long periods under high intensity lighting.
20.
Dispose of all waste in accordance with local regulations.
21.
The external flexible cable of the luminaire is only replaceable by Valoya.
22.
For luminaries supplied with open-end supply cables:
a. Cables should not be concealed or extended through parts of the building structure.
b. Cables should not be located above a suspended/dropped ceiling, or permanently fixed to the building structure.
c. Cables must be visible over their full length, not strained, and protected from physical damage.
d. Cables must be used within
their electrical ratings at the maximum temperature of the installed environment.
BEFORE YOU BEGIN
