Valor Retrofire RF24KBN, Installation & Owner'S Manual

Page: 18 / 46

18
Servicing & Maintenance
CAUTION
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery holder or
the handset! This could cause a short circuit to the
receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
!
Replacing Batteries
Low battery signal: see page 12.
BEFORE changing the batteries, disconnect the
battery holder from the receiver
.
The appliance uses four 1.5 V AA alkaline batteries
for its battery holder and one 9 V alkaline battery for
its handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the o
ff -
season will extend the battery life. Should the batteries
lose power, the control may be operated by manually
turning the control knob at the valve.
To replace the batteries in the battery holder :
The battery holder is located underneath the fi rebox
behind the bottom cover or fret.
1. Slide the bottom cover straight out from the slots
located at the bottom corners of the window frame
or unhook the fret.
2. The battery holder is located to the right of the valve
(position may vary depending on installed options).
Grab the battery holder and pull it out from its
location.
3. Disconnect the battery holder.
4. Replace the batteries with 4 AA alkaline batteries.
5. Reconnect the battery holder.
6. Put the battery holder back in its position.
7. Reinstall the front cover/fret.
Using Handset Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn’t
been installed, refer to the instructions
further on in this manual for the
installation.
Battery holder
QUALIFIED
INSTALLER