6
Inlay Panels and Access Door
24. Level the stove unscrewing the levelling bolts at the
four lower corners of the stove if necessary.
Note: If you are installing the stove in a mobile
home, remove the levelling bolts and use the holes
to secure the stove to the fl oor.
25. Install the gas supply and the venting system.
26. Install the inlay panels at the bottom of each side
panel. The bottom is held in place by magnets.
Secure the top rear of the inlay with a screw.
27. Place the access door and secure it as well as
the front of the inlay panel to the assembly with a
screw. Do not tighten the screw all the way.
21. Place the heat shield on top of the stove and
secure it with 2 screws at the front.
Top Panel and Vent Collar
22. Install the top cast panel on the stove locating its
“feet” within the casting sides.
23.
Rear outlet only:
Fit the cast cover into the
opening of the top panel.
Top outlet only:
Place the vent collar on top of the
outlet to be fi tted over the vent pipe when installed.
Rear outlet
Top outlet