INSTALLER GUIDE
Page 34
14.1.3 Fitting the slider knob (Classica only).
1.
Supplied loose with the fire is a slider knob.
2.
This needs to be screw fixed into the threaded slider
metal shaft. (See Figure 32 for the components
required).
3.
Using the two screws supplied secure the knob in
place. If assemblied correctly the slider should move
freely up and down without any interference.
14.1.4 Fitting the fascia.
1.
Supplied with the fire is a self adhesive control
position label. Peel the backing from the label and place
as in figure 33A.
2.
Place the fascia against the fireplace front surface so
that the two retaining plates at the
back of the fascia are above the two
upper retaining brackets at the top of
the convection box. Lower the fascia
making sure that the rear retaining
plates locate fully into the retaining
brackets on the convection box (See
figure 33A). If the inlet pipe runs
along the front of the fireplace, the
bottom of the fascia will have to be
swung forwards to clear the pipe
while lowering the casting.
3.
Secure the bottom of the fascia
using the two machine screws and
washers supplied (See figure 33B).
14.1.5 Fitting the firefront casting
with its screen and ash pan.
1.
The firefront casting is supplied
with a back screen. This screen
supplied must be fitted onto the casting.
To do this locate the screen in place as
demonstrated in (See figure 34). Using the two
screws supplied secure the screen in place.
2.
Place the firefront firefront casting and ash pan in
place.
© GDC Group Ltd. 2012
Figure 33B. fascia fixing.
Figure 33A. Fascia location (Fascia may differ
from that shown).
Figure 32. Slider Knob assembly
components.
