3
CAUTION
Be careful when using a hose or pressure washing
to clean the areas around the fi replace.
NEVER SPRAY WATER DIRECTLY AT THE
FIREPLACE!
Cleaning AROUND Your Fireplace
Your Valor outdoor gas fi replace will tolerate moderate
amounts of water
on an occasional basis
but is not
designed to be waterproof.
Ensure the fi replace is turned off - including pilot -
before performing any cleaning around it. Use plastic
sheeting to protect the fi replace front and trim from
direct spray while cleaning. Ensure all plastic is
removed before operating fi replace.
Exposure to outdoor UV light
Exposure to outdoor UV light will cause some plated
and painted fi nishes to fade over time. This fading is
unavoidable and not covered under warranty.
To minimize fading, locate the fi replace away from
direct sunlight. Decommissioning and covering the
fi replace over the off -season will also prolong the fi nish.
Decommission During Off -Season
We recommend decommissioning your outdoor
fi replace during the off -season when it will not be used
for an extended period. Decommission your fi replace
by removing the batteries from the battery holder and
turning the gas shut-off valve to the “off ” position.
Upon ensuring the fi replace cannot be turned on you
can then apply a weather protective cover over the
front of the fi replace to help preserve the fi nish and
further protect the appliance from weather.
Note: Do not operate your outdoor fi replace
during cold weather below freezing point
(32°F, 0°C).
Fix the conversion label and replace
the lighting instructions
The data label and lighting information cards are
located either under the fi rebox near the gas valve or
on the right side of the fi rebox. They are retained to the
appliance by a wire.
Data label and lighting
instructions located near the
gas valve or to the right of
fi rebox
1. Fix the conversion label on the data card as
indicated.
2. Remove the existing lighting instructions by cutting
the card out near its fi xing point.
3. Staple the new lighting instructions to the data card
near its fi xing point.
4. Place back in appliance.
fi replace
data card
lighting
instructions
conversion
label
Supplementary Owner’s Information
