OWNER’S GUIDE
Page 8
In the unlikely event of failure of the ignition mechanism the pilot can be lit with a long
match or taper – See the next page.
•
When the pilot has lit keep the knob depressed for about ten seconds to allow the flame
sensing probe to warm up.
•
The control knob can then be set to your preferred heat level. The settings are:
Knob
Position
Radiants Condition
2
Centre radiant on low. Outer radiants off.
3
Centre radiant fully on. Outer radiants off.
4
Centre radiant fully on. Outer radiants on low.
5
All radiants fully on.
•
To turn off
partially depress the knob and turn clockwise to off.
Wait at least three
minutes before attempting to relight.
Lighting with a match or taper
•
Depress the control knob and turn anticlockwise towards the 1/IGN position.
•
While keeping the knob depressed, light the pilot by inserting a long match or taper into
the pilot viewing opening (See figure 3).
•
When the pilot is alight, keep the knob depressed for about ten seconds to allow the
flame sensing probe to warm up before setting to your preferred heat level.
•
For your own convenience, have the heater serviced as soon as possible.