INSTALLER’S GUIDE
Page 25
10.11
To replace burner plaques
See fig. 35.
10.11.1
Remove the loose coals, the front
base coal, rear base coal and front burner
trim.
10.11.2
Remove the plaque clamping strips
by detaching 8 screws.
10.11.3
Remove the plaques and the
combination gasket between and under the
plaques. If necessary remove the gauze and
the gasket beneath it.
10.11.4
If necessary fit a new gasket below
the gauze. Clean and replace the gauze. Fit a
new combination gasket below the plaques.
Push the gasket ends inwards to form a
dividing gasket between the plaques.
10.11.5
Place the new left hand plaque in
position. The left side of the plaque must
touch the inside edge of the retaining flange
at the left side of the burner well.
10.11.6
Place the new right hand plaque in
position. Make sure that the centre section of
the combination plaque is between the two
plaques. If there is any play between the
plaques and the end retaining flanges, push
the plaques firmly to the left squeezing the
centre section of the combination gasket
between the two plaques. Any gap should be
between the right side of the plaque and the
right side retaining flange.
10.11.7
Fit the front and rear plaque clamping strips. Make sure that the plaques are as far
to the left as possible. .
It is important that the left side plaque is accurately positioned
so that it has the correct relationship to the pilot.
Fully tighten the clamping strips.
10.11.8
Refit the coals as described in the installation instructions.
10.12
To remove the appliance from the fireplace
10.12.1
Remove the front fascia, castings, loose coals, front base coal and rear base coal.
10.12.2
Slacken the hexagonal adjusters on the cable retainers and unscrew the
thumbscrews to release the cables.
10.12.3
Refit as described in the relevant installation sections.
Fig. 35 Burner plaque positions