INSTALLER’S GUIDE
Page 21
10.4
To remove the burner unit
10.4.1
Remove the “ash pan” casting and bottom front casting.
10.4.2
Remove the loose coals, the front base coal, rear base
coal and front burner trim.
10.4.3
Disconnect the control linkage by removing the knurled
screw which connects the control linking bar to the control pivot
unit (see figure 28).
10.4.4
Support the inlet isolating elbow to avoid straining the
pipework and disconnect the appliance from
the elbow.
10.4.5
Detach the burner unit from the
convection box by removing three screws
(see figure 29). Lift the burner unit clear.
10.4.6
Refit in the reverse order. Make sure
that the tab at the right side of the battery box
is in front of the “L” shaped bracket which
projects up from the fire case base. See
figure 29.
10.5
To remove the electronic
ignition generator
10.5.1
Remove the burner unit – See section 10.4
10.5.2
Remove the battery.
10.5.4
Remove the two leads to the switch and remove the spark lead, marking them if
necessary to ensure that they are replaced on to the correct terminals.
10.5.5
Remove the two fixing screws that attach the generator unit to the bracket. The
igniter generator can now be exchanged.
10.5.6
Refit in the reverse order. When refitting the burner unit, make sure that the tab at
the right side of the battery box is in front of the “L” shaped bracket which projects up
from the fire case base. See figure 29.
Fig. 29 Burner fitting
Fig. 28 Control linkage