OWNER’S GUIDE
Page 10
Figure 7. Coal bed location
Figure 6. Window surround fitting
3.
After cleaning, replace and
secure the window unit to the
firebox by turning the two screws
1
/
4
turn clockwise with the
screwdriver.
Refit the window surround by
sliding the surround upwards to
locate its upper tabs in the slots
underneath the outer case hood.
Push the bottom of the surround
fully against the case cross panel.
Drop the surround down so that
the two screw heads at the back of
the surround locate in the
keyholes in the cross panel. See
figure 6.
Ceramic Coal
•
This product uses a fuel effect piece containing
Refractory Ceramic Fibres (RCF), which are man-
made vitreous silicate fibres. Excessive exposure to
this material may cause temporary irritation to eyes,
skin and respiratory tract. Consequently, it makes
sense to take care when handling this article to
ensure that the release of dust is kept to a minimum.
•
Although light coatings of soot are usually burnt
off during normal use, the coal may benefit from
occasional cleaning.
•
Should any soot accumulation become excessive,
the fuel effect piece should be removed from the
fire for cleaning. Cleaning should be carried out in
a well ventilated area or in the open air by gently brushing with the pieces held away
from your face so that you avoid inhaling the dust. We do not recommend the use of a
normal domestic vacuum cleaner which may blow dust back into the air.
•
The coal can be lifted out of the fire box when the window surround and glass have
been removed as described on page 8.
•
When replacing the coal, make sure that it rests on the ledges at the sides of the firebox
and that its back face is touching the horizontal rib at the back of the firebox. See
figure7.
•
Replace the window and surround after cleaning.
