CLEANING YOUR FIRE
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the
guard and trims using soapy water.
Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see below for how to remove the
radiants. (See figure 5)
REPLACING THE RADIANTS
Always use the correct type of replacement radiant. Ask for Valor Fires part
number 5132071 (Single Radiant). Turn the fire off and allow it to cool before
attempting to remove the radiants
.
To remove the dress guard, gently pull the centre of the dress guard with one hand
and carefully spring out one end of the dress guard with the other. Slide the other
side of the dress guard clear of the
fixing holes. Take care not to scratch
the trim.
Lift the radiant upward to clear the
metal retaining bar then pull out
bottom first.
Fit the new radiant by inserting its top
under the top lip of the radiant box
then swing the bottom of the radiant
over and behind the retaining bar.
It
is important that the rear face of
the radiants rest against the
horizontal ribs in the rear panel.
There will be a small gap between
their bottom front edges and the
retaining channel at the front of the
radiant box.
Replace the dress
guard. To do this locate one side of
the dress guard into the two side
fixing holes. Spring the dress guard slightly and locate into the opposite fixing holes.
Take care not to scratch the trim.
Page 39
©
GDC Group Ltd. OCT 2016
OWNER GUIDE
Figure 5.
