INSTALLER’S GUIDE
Page 27
Figure 29. Front Surround Removal
Figure 28. Burner plaques
5.
Place the new left hand plaque in
position. The left side of the plaque must
touch the inside edge of the retaining
flange at the left side of the burner well.
6.
Place the new right hand plaque in
position. Make sure that the centre section
of the combination plaque is between the
two plaques. If there is any play between
the plaques and the end retaining flanges,
push the plaques firmly to the left
squeezing the centre section of the
combination gasket between the two
plaques. Any gap should be between the
right side of the plaque and the right side
retaining flange.
7.
Fit the front and rear plaque clamping
strips. Make sure that the plaques are as far
to the left as possible.
It is
important that the left side
plaque is accurately
positioned so that it has the
correct relationship to the
pilot
.
Fully tighten the
clamping strips.
8.
Refit the ceramic fuel
effects as described in section
10 of this manual.
13.2
To Remove the Front
Surround
1.
Remove the bottom front
cover casting.
2.
Lift the fire front casting
clear. (Where applicable by lifting the fire front casting up and forward to release the
locating screw heads at the back of the casting from the keyholes in the surround sides.)
3.
Remove the two screws securing the bottom of the front surround to the sides of the
convection box. Raise the front surround to allow the retaining lugs at the top to clear the
slots in the convection box hood and then lift clear. See figure 29.
4.
Replace in the reverse order.
