Page 14 of 14
GEN2-V1 12ft-Instructions (Severe Weather) doc:r1
To move the elbow of either Extension arm more outward you will move the Wrist Assembly (which holds the end of
the Extension Arm farther towards the end of the Valance Tube; And you will move the Wrist Assembly farther
towards the Centre of the Valance Tube to move the elbow (or centre joint) of either Extension Arm towards the wall.
To make this adjustment:
While the Awning is rolled out, loosen the Philips head Screws on
the bottom of the Wrist Pin Assembly (shown in the photos to the
right;
DO NOT COMPLETELY REMOVE THESE SCREWS.
You
can slide the Wrist Pin in either direction (as required) within the
channel on the bottom of the Valance Tube. Be careful to ensure
that you maintain even alignment of the end of the Valance Tube
and the Roller Tube while making this adjustment. By moving the
Wrist Assembly toward the outside ends of the VALANCE TUBE
you will move the EXTENSION ARM Elbow farther out from the
wall; and closer to the wall if you move the Wrist Assembly toward
the centre of the VALANCE TUBE.
Roll your awning in and out a few times making small adjustments until it operates correctly and smoothly. Once
complete; while the Awning is out re-tighten the Philips head screws on the bottom of the Wrist Assemblies.
Should you still have any problems that you can not rectify, please call our customer service department at 1-888-
875-4844. We also have a Q&A section on our website at
which may address questions you
may have.
Thank you.