88
Owner’s Information
Using Handset Wall Holder
Your
fi
replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further on in
this manual for the installation.
Locating Lighting, Operation and Rating
Information Plate
The Lighting, Operation and Rating information is
located on a plate under the
fi
rebox.
To access the plate, remove the inner trim and grab
the plate and slide it out to read it. There is important
information on both sides of the plate.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance’s serial number can also be quoted. This
number is on the rating plate, which is located under the
burner. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.
Operating Your Fireplace
There are two ways to control your
fi
replace.
1. Thermostatic Remote Control;
2. Wall Switch.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 9–13.
The Wall Switch can be used to turn on, off and to
increase or decrease the
fl
ame height—see page 13.
NOTE:
The remote control in the AUTO mode will
override the wall switch.
Thermostatic Re-
mote Control
Wall Switch
Wall Switch
Remote control
handset
Gas valve
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your
fi
replace.
Handset and Wall Switch:
Press and hold the OFF
button for a second (either on the handset or the wall
switch).
If the
fl
ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to
ensure that your
fi
replace will not turn on when you
don’t want it on.
First, ensure your
fi
replace is turned off—including
the pilot—and cold BEFORE going ahead.
• Turn the dial on the gas valve from the ON position
to the MAN position as shown. Turning the dial to
MAN (arrow up) will ensure that the main burner can
not come on. The pilot will remain on if it is lit.
• Alternately, remove all batteries from the receiver
as well as the battery from the handset.
Automatic Shut-Off
(in certain conditions)
Your
fi
replace’s remote control is equipped with an
automatic shut-off mechanism which is activated in
certain conditions. See page 13 in the
Remote Control
Operation
section for a description of this feature.
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA PLATE
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi
replace cool
fi
rst before touching it.
!
OWNER’S
INFORMATION
