![Valor 650JLN Owner'S Manual Download Page 29](http://html1.mh-extra.com/html/valor/650jln/650jln_owners-manual_3439504029.webp)
29
29
Co-Linear Vent Installations
• The
fi
replace dimensions are shown in the
Dimensions
section of this manual.
• Place the appliance (
fi
tted with the co-linear adapter)
near the
fi
replace opening but allow space for
manipulating the chimney liners on to the appliance.
• Drop the 3-inch diameter
fl
exible liners into the
chimney from outside.
• Fit the liners to the co-linear adapter paying attention
to inlet and exhaust and move the appliance to its
proper position. Be aware of the minimum liner bend
radius and maximum liner horizontal run shown at
right.
• Fit the termination kit and
fl
ashing to the exterior of
the chimney.
Secure the appliance to the
fl
oor or wall if necessary.
Rear or Top Outlet Conversion to Co-Linear
Liners using Valor 556CLA Co-Linear Adapter.
(Generic co-axial to co-linear adapter boxes may
also be used as an alternate to the 556CLA).
Only for use when retrofi tting a solid-fuel burning
fi replace and chimney.
The appliance must not be connected to a chimney
fl
ue
serving a separate solid-fuel burning appliance.
Requires 556CLA Co-Axial to Co-Linear Appliance Adapter (or, alternatively, a generic adapter), two lengths of
3-inch diameter
fl
exible chimney liner, co-linear termination kit and
fl
ashing and either high wind vertical vent
terminal cap or a low pro
fi
le vertical termination.
Flashing
2 x 3”
liners
3” min.
bend radius
Co-linear
adapter
2 x 3”
liners
18” max.
horizontal run
Co-linear
adapter
650
engine
Max.
40’
Co-linea
adapter
Approved co-linear
termination or approved
co-linear adapter
and approved
co-axial
termination
NOTE: Min. 1/2”
gap required
for air flow
Co-Linear Venting
Co-Axial to Co-Linear Adapter
(alternate to 556CLA)
10”
10”
3” Inlet & Exhaust
Collars
7-5/8” dia.
collar
556CLA
2 x 3” Liners
26-3/4”
16”
556CLA
2 x 3” Liners
26-3/4”
16”
556CLA on
Rear Outlet
556CLA on
Top Outlet
Alternate to 559CLT/559FSK Conversion
559FSK Flashing Kit
559CLT Co-Linear Terminal
Co-Linear installation into existing F/P
556CLA Kit
Terminal Cap
Co-Linear to Co-Axial
Adapter
Flashing
QUALIFIED
INSTALLER