21
21
• A non-combustible hearth is not necessary in front of this appliance.
• Note that the unit is installed at the framing stage and
fi
xed to framing using support angles. See page 31. The
wall
fi
nish is then installed over the support angles up to the front frame on the unit, on the sides and up to the
stand-offs on the top.
38-3/4” (984 mm) to underside of
header and cavity height
30-3/4” (768 mm)
to wall finish
33”
(838 mm)
Wall Finish
FRAMING DIMENSIONS
16” (406 mm) min. straight out
or off the top venting.
Allow for elbow if rear vent with rise.
MINIMUM
1/2” (13 mm) space
between bottom of backing
plate and surface
of hearth or
floor finish in front for air flow
Combustible framing
allowed beneath fireplace.
When the appliance is
installed directly on
carpeting, tile or other
combustible material
other than wood
flooring, the appliance
shall be installed on a
metal or wood panel
extending the
full width and recessed
depth of the appliance
When the appliance is installed directly on carpeting, tile or other combustible material other than wood
fl
ooring, the appliance shall be installed on a metal or wood panel extending the full width and depth of the
appliance.
Framing
46” (1168 mm) min.
46”
(1168 mm) min.
65”
(1651 mm) min.
FRAMING IN A CORNER
QUALIFIED
INSTALLER
