Valor 650ILN, Installation & Operating Instructions Manual

Page: 33 / 43

33 33
Remote Control Operation
Temperature
Use this setting when you come in and want to enjoy a set temperature.
1. Select either the
☼
TEMP
MODE
or the
☽
TEMP
MODE
by briefly pressing the
SET
button.
2. Hold the
SET
button until the
TEMP
display flashes.
3. Set the desired temperature with the or the buttons.
Note: 4.5°C/40°F is the minimum temperature setting.
4. Press the
OFF
button or simply wait and the display will go to the temperature control mode.
Note: If you would like the Nighttime Setback temperature control to turn off, decrease the
☽
TEMP
MODE
setting until [---] appears on the display.
Your fi replace will reach the set temperatures and the remote handset will check the tempera-
ture every fi ve minutes, adjusting the amount of fuel needed to give you a steady, even heat.
5. The display must remain in
TEMP
mode on the remote handset.
hours minutes
Timer
It is possible to program two periods of time per day at which your fi replace will turn on and off
automatically.
For example, you can set your fi replace to turn on in the morning just before you get up (P1
☼
[
start time
])
and to turn off when you leave for the day
(
P1
☽
[stop time]). Then, you can set your
fi replace to turn on again at the end of the day (P2
☼ [
start time
])
and to turn off when you go to
bed at night (P2
☽
[stop time]).
If you wish to set only one time period at which your fi replace will turn on and off, program P2
☼
[
start time
]
and P2
☽
[stop time] for the same time as P1
☽
[stop time].
1. Select
TIMER
mode by briefly pressing the
SET
button.
2. Press and hold the
SET
button until
TIMER
is displayed on the lower right hand side.
3. Press and hold the
SET
button until P1 ☼ and the time display flashes. Set the start time by
pressing the button for the hour and the button for the minutes. Then, briefly press
SET
to P1
☽
and set the stop time in the same manner you just set P1 ☼ .
4. Briefly press the
SET
button again for the next burner cycle time, which will be P2
☼ and
P2
☽
.
5. Once all four times are set, press
OFF
or simply wait to complete programming.
6. The remote handset must remain in
TIMER
mode to function automatically.
Timer Programming Example
(default temperatures shown)
6:00 a.m.—
P
1
Start time
5:00 p.m.—
P
2
Start time
6:00 a.m.—
P
1
Start time
9:00 a.m.—
P
1
End time
9:00 p.m.—
P
2
End time
Set temp 74 ˚ F Set temp 40 ˚ F Set temp 74 ˚ F
Set temp 40 ˚ F
☼ ☼
☼
☼
☼
☽ ☽
☽ ☽