CLEANING YOUR FIRE
Turn the fire off and allow it to cool before attempting any cleaning.
Normally the fire will only need dusting. The bright metal trims may be cleaned with a
damp cloth and dried with a soft duster. Obstinate marks can be removed from the
guard and trims using soapy water.
Never use abrasive cleaners.
The radiants can be cleaned with a soft brush - see following section for how to
remove the radiants.
REPLACING THE RADIANTS
(See figure 5).
Always use the correct type of replacement radiant. Ask for Valor
Fires part number 5132071 (Single Radiant).
Turn the fire off and allow it to cool before attempting to remove the radiants
.
-
Remove the dress guard by pressing down the two hooks at the top. Tilt the guard
forward and lift out.
-
Lift the radiant upward to clear the metal retaining bar then pull out bottom first.
-
Fit the new radiant by inserting its top under the top lip of the radiant box then swing
the bottom of the radiant over and behind the retaining bar.
It is important that that
the rear face of the radiants rest against the horizontal ribs in the rear panel.
There will be a small gap between their bottom front edges and the retaining
channel at the front of the radiant box.
-
Replace the dress guard. Locate the bottom of the dress guard in the two holes in
the bottom panel apron. Push the guard back so that the two spring projections at the
top of the guard engage in the slots under the front decorative canopy.
Page 35
©
GDC Group Limited 2014.
OWNER GUIDE
Figure 5. Replacing radiant(s) - grill shown may differ on Hemsley but same hooks
