To light the fire (Electronic ignition-Helmsley).
The control is shown in figure 3.
-
Depress the control knob slightly and turn
anticlockwise towards the 1/IGN position. Do not
apply too much pressure as this will cause
resistance to be felt.
Depress the control knob. Sparks should be
generated at the pilot. The sparks should ignite the
pilot.
If the pilot does not light, turn the control knob back
to the ‘OFF’ position and try again. The pilot flame
can be seen through the opening immediately below
the right hand centre radiant.
If no sparks are generated at the pilot the battery may have no power. The battery
can be replaced as shown later in this guide.
-
When the pilot has lit keep the control knob depressed for about ten seconds to
allow the flame sensing probe to warm up.
-
The control knob can then be set to your preferred heat level.
To turn off
partially depress the knob and turn clockwise to off.
Wait at least three
minutes before attempting to relight.
The control knob can then be set to your preferred heat level. The settings are:
Page 34
©
GDC Group Limited 2014.
OWNER GUIDE
Figure 3.
Control Knob
Position
Radiants Condition
2
Centre radiants on low. Outer radiants off.
(The right hand centre radiant will glow slightly
more than the left hand centre radiant due to
the pilot flame)
3
Centre radiants fully on. Outer radiants off.
4
Centre radiants fully on. Outer radiants on low.
5
All radiants fully on.
