Valor 1600IN, Installation & Owner'S Manual

Page: 9 / 64

9
WARNING
DO NOT ATTEMPT TO TOUCH THE DATA CARD
WHILE THE FIREPLACE IS STILL HOT!
Let the
fi replace cool fi rst before touching it.
Info
card
Window
The info card is located behind the front
panel below the window.
Thermostatic
Remote Control
Wall Switch
Wall Switch
Remote control handset
Owner’s Information
1. Pull on the plate next to the
wall switch to access the
batteries.
2. Disconnect the snap
connector from the battery
holder.
Do not pull the
connector by the wire!
3. Replace the batteries with
4 AA alkaline batteries
orienting them as indicated
inside the holder.
4. Reconnect the snap
connector to the battery
holder.
5. Put the battery holder back
in its place beside the wall
switch and snap it in place..
Using Remote Control
Handset Wall Holder
Your fi replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further
on in this manual for the installation.
Locating Lighting, Operation and Rating
Information Card
The Lighting, Operation and Rating information is
located on a card at the right hand side of the
fi replace
opening. The card is attached under the plinth.
To access the card, remove the barrier screen, side
doors and the plinth. Grab the card and pull it out.
There is important information on both sides of the
card.
!
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be
helpful if the appliance’s serial number can also
be quoted. This number is on the rating plate. The
replacement parts are shown at the end of this manual.
Please always quote the part number and description
when requesting spare parts.
Operating Your Fireplace
There are two ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch.
The Thermostatic Remote Control can be programmed
to function automatically—see pages 11–15.
The Wall Switch can be used to turn on, off and to
increase or decrease the
fl ame height—see page 16.
How to Turn Your Fireplace OFF
(including pilot)
Familiarize yourself with each of these methods before
operating your
fi replace.
Press and hold the OFF button for a second (either on
the handset or the wall switch).
If the fl ames are on, they go down and you hear the
valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from
the remote control.
Disconnect
connector
OWNER’S
INFORMATION