11
Replacing batteries
Low batteries signals:
• Handset: battery icon on display shows 1 lit bar
• Holder: frequent beeps for 3 seconds when valve
motor turns.
BEFORE changing the batteries, turn the
fi
replace o
ff
(including pilot) and let it cool.
The
fi
replace uses four 1.5 V AA
alkaline
batteries
in a separate battery holder located next to the
wall switch and two 1.5V AAA
alkaline
battery in its
handset. Batteries should last one to two seasons,
depending on usage. Removing the batteries in the
o
ff
-season will extend the battery life.
To access the battery holder, remove the magnetic
cover on the remote wall switch by pulling on it; the
battery holder is attached to it.
WARNING
Do not attempt to access the batteries
while the
fi
replace is hot! Let the
fi
replace cool
fi
rst before touching it!
Caution
Do not use a screwdriver or other metallic
object to remove the batteries from the battery
holder or the handset! This could cause a short
circuit.
To replace the batteries:
1. Remove the used batteries from the battery
holder and replace with 4 new AA 1.5V
alkaline
batteries.
Do not mix old and new batteries!
2. Reinsert the battery holder in the wall switch box
snapping the magnetic cover in place.
Using Handset Wall Holder
Your
fi
replace equipment includes a wall holder to
store the handset. If it hasn’t been installed, refer to
the instructions in the
fi
replace Installation Manual.
Caution
Do not put batteries in the receiver as leaking
acid could damage its circuit board.
Remote and wall holder
Battery
holder
& wall
switch
Fireplace
Receiver
Gas valve
Receiver and gas valve located on bottom of
fi
replace
under removable panel. Battery holder located next to
wall switch.
