6.
There is a length of self adhesive foam
seal supplied with the fire. This will need to
be fitted to the outer rear edges of the side
and top flanges of the hotbox. Cut a 485mm
length of foam seal. Be careful not to stretch
the seal when measuring. Remove the
protective backing from the foam seal and fit
this to the rear of the top flange (See figure
15). Cut two 580mm lengths. Fit these to the
rear outer edges of the side flanges. Ensure
that there is no gap between the foam seals
where they meet at the top flange (See
figure 15).
7.
This appliance is supplied with a rear
ceramic support bracket. Fit this using two
screws supplied (See figure 16).
Page 25
©
Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
Figure 16. Fitting the rear ceramic support.
Figure 15. Fitting the foam seal