4. PACK CONTENTS
Carefully remove all the contents. Take special care in handling the ceramic walls and
the ceramic fuel effect. After fitting the slide control linkage, take care not to bend or
distort the slide control linkage when handling the fascia.
Check that all the listed parts are present and in good condition.
The items required for this appliance are packed in sections (See figure 8)
Section 1 - Fire Unit contains:
1
Burner and hotbox unit.
(On Dream models a slider control is fitted to the convector box).
1
Burner front baffle (Only supplied on ‘Dream’ models).
1
‘T’ connector including pressure test point, nut and olive for 8mm inlet pipe.
1
Flue restrictor.
2
No 8 x 3/8 Screws (For flue restrictor).
2
No 8 x 3/8 Screws (For rear ceramic wall support bracket).
2
Washers (For fascia hanging).
2
M4 x 25 machine screws (For fascia securing).
2 M4 x 10mm countersunk screws for slider fixing.
2 M4 x 7mm screws (For control knob assembly fixing on Dream model).
1
Ceramic fuel effect pack including a fuel effect (Not shown), a ceramic back wall
and a pair of ceramic side walls.
2
Small “U” seals for hotbox side flanges.
4
Woodscrews.
1
Strip of floor sealing tape.
6
Fibre plugs.
2
Fire retaining cables.
2
Cable clamps.
4
Eyebolts.
1
Rubber grommet.
1
PP3 Battery.
1
Knurled shouldered screw (For control linkage fixing).
1
Smoke match tube.
1
Rear ceramic wall support bracket.
1
Length of self adhesive foam seal.
1
Self adhesive control position label.
1
Control knob and bracket assembly.
1
Literature pack (Not shown).
Page 18
©
Baxi Heating U.K. Limited 2009.
INSTALLER GUIDE
