12. FASCIA INSTALLATION
BEFORE FITTING THE FASCIA, COMPLETE THE INFORMATION IN THE
WARRANTY AND SERVICE SECTION OF THE OWNER GUIDE (See last pages of
the OWNER guide).
12.1 Fitting the fascia.
1.
Unpack the fascia. Carefully lift the fascia. Place the
fascia against the fireplace front surface so that the
four retaining plates at the back of the fascia are
directly above the four retaining brackets of the hotbox.
There are two at the top of the hotbox and two to the
side of the burner module. Do not lift the fascia too
high as the bottom of the fascia will foul against the
control knob. Lower the fascia unit making sure that the
retaining plates locate fully into the brackets on the
hotbox (See figure 24).
2.
Unpack the fascia casting and lower into the hotbox
as in figure 25. The side of the casting has slots that
locate over the front of the burner unit (See
figure 25). At the rear of the casting there is a
small shelf. This should locate under the ribbed
panel. After locating the casting gently push the
front of the casting.
13. FITTING THE CERAMIC FUEL EFFECT
The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the guide for the ceramic fuel effect be placed inside or
attached to this guide and handed to the customer following completion of the ‘final
review’ section.
Page 26
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 25. Fascia casting location
Figure 24. Fascia location
