8
6. After all wires are attached and secured, make sure the power
switch on the ICON LINK is turned on, and then close the Valley
panel door and turn the main disconnect switch on.
7. If your ICON Link came with the Theft Monitor as a
separate kit, please wire it in as shown above. After wiring in
the Theft Monitor kit, the dealer must call AgSense to enable
the feature. The theft monitor will not work without
completing this step.
8. After completing Step 7, and setting up a phone number/s in the
Alerts config, test the theft monitor feature with the pivot off, by
removing the speed wire from a tower box terminal strip for a
couple minutes, after you receive the alert, you can place the wire
back into the tower box terminal strip.
